Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I'm trying to achieve asymmetric routing through the same ASA FW.I have 3 interfaces on the FW, 2 internals and 1 external.I want the traffic from inside to be able to go outside and come back but NOT go back through the internal interface it cam...
Hi,
I'm in the process of designing a spoke to spoke DMVPN solution with iBGP routing.
The spoke to hub communication works fine (PC1 & PC2 can successfully ping 10.10.1.1) but not the spoke to spoke's (PC1 & PC2 can't ping each other).
Any idea wh...
I've managed to add static routes to the spokes towards one another but they still can't ping each other.
Spoke1:
192.168.2.0/24 through 192.168.1.1
Spoke2:
192.168.0.0/24 through 192.168.1.1
Hi,
Thanks for your reply.
It's a typo indeed.
I'm only missing the tunnel mode gre multipoint on the spokes then.
I'll see with our device supplier how to add it.
Hi,
Thanks for your reply.
What source interface or IP did you put in the ping command from Spoke 1?
I pinged Spoke2 from PC1, which is behind/connected to Spoke1.
Is the issue still that devices behind Spokes can't communicate across the tunne...
"Secondly, whatever routing device you ping from must have the destination network in it's routing table or learn a default through a dynamic protocol or statically configured route."
I agree completely.
How come I can't ping Spoke2's GRE IP from Spo...
