Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are simply trying to create a device-alias, which we have done many times before without issue, but now we are getting this error on commit: "zone: Device-alias enhanced zone member present"switch-a# config tEnter configuration commands, one per ...
I am trying to find out where zoning changes are logged to. For example, an admin creates a new zone, adds it to the active zoneset and commits the changes (we usually do this via CLI). A little while later we get a report of an issue and would lik...
Hello. I am working a new install of DCNM on Linux and was going through the installer.properties file and at the end it has this section: #------------------------------IBM Raven Support----------------------#Set true if Vendor is IBM, by default f...
It seems I needed to run the commands from the "partner" switch.This is our setup:FABRIC-A --> switch-a & switch-2a <--I ran the same device-alias commands here and it worked.FABRIC-B --> switch-b & server-2bIn the past I could run commands from ...
A small update, but no real answer... I was on a webex with a Cisco support person and asked them this question and they were not sure but did say that it might only be to set the DCNM Web Client homepage to "IBM Data Center Network Manager" instead ...
