Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,Someone on the IDS group suggested I post this here instead. Apologies if this has been covered before, I did a quick scan of forums here only found one relevant post, which didn't help in my case...I am dealing with a 'base license' Cisco 550...
Hello,Apologies if this has been covered before, I did a quick scan of forums here but might have missed a relevant post. I am dealing with a 'base license' Cisco 5505 ASA 8.0(2) using ASDM 6.0(2). I've noticed that normal background network traffi...
Thanks for the advice, I did receive a solution on the Firewall forum, as suggested above. For reference, the solution was:To remove:no threat-detection rate scanning-threat rate-interval 600 average-rate 5 burst-rate 10 Then add your new configurat...
Thank you very much! The 'no' command is just what I was looking for... clearing the existing rule allows me to re-establish with updated thresholds.Thanks also for the pointer to the CSC number; upgrading the firmware might be something I try as a...
Thank you for your reply... I'll check the Firewall section now!>Obviously if you will adjust a setting that is already configured it should not be accepted.This doesn't seem obvious to me; this is exactly what I am trying to do, adjust an already c...
