Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have been having problems accessing hosts connected via the inside interface on an ASA 5520. The thought just occured to me that the interfaces are gigabit ethernet and the outbound connection is an 100 mb connection. Could this be the cause of m...
I have successfully been able to allow outbound access from inbound hosts on the appliance; however, I have only one outbound IP address and had to configure outbound access using static PAT. What I need to do is to configure access to certain inbo...
Ajay,Hopefully, you will read this; but, I did add the outside IP address to the interface; but, still I am unable to access the inbound host. Should I just update the appliance?Anthony
Ajay,Should I add an IP address there? I didn't because in Document ID: 63872, entitled, "PIX/ASA 7.x: Port Redirection(Fowarding) with nat, global, sttic and access-list Commands," on page 2, below the section entitled, "Allow Outbound Access," no...
Ajay,I had changed the default RDP port on the local host to port 3400, which explains why I had to leave the static and access-list entries for that port as they were. I have been trying to remote to the local host from an outside network; but, I a...
Ajay,I believe that you have answered my question. What I meant is that I have another inside host, let's say its IP address is 10.28.100.23 and I need to be able to have lelnet open; so, if I am interpreting your response correctly, I can just add...
Ajay,Thanks. Can I use the same ACL name or number for the other inside hosts or do I need to enter a different ACL name or number, such as ACL 102 to open the ports for the other inside host?Anthony
