Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Tom is correct, but if you are using VCAT and LCAS at the end-points the circuit between will not be a VC4-4c. It will be 4 individual VC4 circuits that are stiched together by the VCAT/LCAS code. VCAT will make the 4 individual VC4 circuits look...
Mohamed,You cannot do a MSP1+1 on a Gig port on any SONET/SDH box. Because MSP1+1 is a SONET/SDH protection switching scheme. It is not an enterprise/data switching scheme. I do not know what the client equipment is you are connecting this to bu...
Jim,In your original post you said "...extend it over our in house single mode fiber a couple miles away"... So if there is a remote possibility you will do this, then you should get the intermediate reach SFP. As Tom points out, it will go up to 9...
Tim,Tom provided the answer to the need for an attenuator. On the link "coming up" you may see the link come up, but the protocol is not up. Again, it depends on the port... ethernet.. pos... whatever it is.Mike
The question for you is which of the three SFPs the PA-POS-1OC3 card uses did you buy? POM-OC3-MM you want MultimodePOM-OC3-SMIR you want single modePOM-OC3-SMLR you want single modeMike DooleyCisco Optical TAC
