Hi,I planned use NSO to configure Remote-Access VPN on a Juniper SRX. I started to configure VPN using the Juniper-junos NED to get the XML format, but I realised that the NED is not complete, somme commands are not available.Is use the NETCONF NED a...
Hello,Running NSO 6.3, python 3.12, everything worked fine until this morning, when reloading packages, I got this result:admin@ncs# packages reload
reload-result {
package cfs-vlan
result true
}
reload-result {
package cisco-nx-cli-5.25
...
Hello,with the following yang, I defined a device with a list of vlans (id, ip_add and description). augment /ncs:services {
list rfs_router_intf {
tailf:info "RFS interfaces vlan";
key rfs_name;
leaf rfs_name {
typ...
Hello,I created a python-and-template skeleton for Vlan service.Very simple yang:- vlan ID- description- list of switches with an IP address.The XML configure a "interface vlan <ID> with IP and description.The idea is to use python to "calculate" the...
Hello,I'm writing a very basic service in order to configure an interface vlan on a list of switch. Le vlan number is the same for all switches, and each switch has its own IP address for this vlan interface.When I create the service one switch, it w...
OK, my "breakpoint()" was out of the class (at the end of the file, it was a test), as are the lines for debugger waiting (at the top of the file, just after the imports).So I tried to configure these lines inside the cb_create function, and package ...
Hi,looking at ncs-python-vm.log I can see this:[root@nso-dev-nc-nso6 logs]# more ncs-python-vm.log
<INFO> 3-Sep-2024::12:05:02.225 nso-dev-nc-nso6 ncs[17080]: rfs-router-intf :: start
> /root/nso-instance-NOEL/state/packages-in-use/1/rfs-router-intf/...
Looking deeper in the logs, it seems the last service deployment started 29 Aug (yesterday) and terminated 30 Aug (today). And after that, the VM does not start running anymore...<INFO> 29-Aug-2024::08:48:08.41 rfs-router-intf ncs-dp-193457-rfs-route...
Hi,I don't understand why NSO est behaving like this, but I understand that when I use Python, it's all or nothing (at least when using a loop).Thanks a lot for your analysis, very appreciated!
