Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have two cisco catalyst 9300 series switches which are connected to each other over te1/1/1.The problem is that when I e.g. perform a reload on one switch (switch-01) I get an err-disable on (switch-02)ERR_DISABLE udld error detected on Te1/1/1, pu...
Hello,is there any possibility to install a IOS upgrade/update without getting a command prompt with the install command?I do it like this:install add file flash:FILE.bininstall activate(And then comes the command prompt: This operation requires a re...
Switch 1 udld intswitch-01# show udld ten 1/1/1
Interface Te1/1/1
---
Port enable administrative configuration setting: Follows device default
Port enable operational state: Enabled / in aggressive mode
Current bidirectional state: Unknown
Current o...
Switch 1 INTswitch-01# show run interface ten 1/1/1
Building configuration...
Current configuration : 299 bytes
!
interface TenGigabitEthernet1/1/1
description -> switch-02 XX
no switchport
vrf forwarding XX
ip address 192.168.1.2 255.255.255.2...
