Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've setup 1 x Controller and and 2 x APs. All of them are Cisco 3802 and all of them have same software 8.5.140.0 and Mobility Express capable. All of the APs are connected to same switch with and same access Vlan. These APs were bench tested and no...
I've been trying to configure Cisco Mobility Express on Cisco 3802i. However could anyone please advise why I am not getting 'VLAN' option in below screenshot. Any advise would be highly appreciated. Thank you
I've been working on a Cisco 3802i WLC. I am unable to ping the Management IP address of WLC. - I've followed step-by-step instructions from Cisco, how to configure 3802i WLC. - Configured with proper IP address, subnet mask and gateway IP address. -...
I've been working on a Cisco 3802i WLC. I am unable to ping the Management IP address of WLC. - I've followed step-by-step instructions from Cisco, how to configure 3802i WLC. - Configured with proper IP address, subnet mask and gateway IP address. -...
I've downloaded and installed Cisco Mobility Express Software in Cisco Access Point 3820i. But after reboot, it doesn't broadcast SSID. I've gone thru CLI configuration and configured the whole Controller but still it doesn't broadcast the SSID. I'v...
Thanks Leo for the suggestion. I have two questions here... - We didn't buy the products with support. Would you think Cisco will still allow me to open case?- Out of curiosity, if this was bug then wouldn't have affected during initial configuratio...
Tried that. Ping didn't work. I can't even ping the WLC from switch where it WLC is connected to. In Switch show cdp nei doesn't show WLC's IP address either.
In addition, on the Switch, show cdp nei doesn't show WLC's IP address, other AP's IP address does appear properly.on the WLC, show cdp nei shows Cisco 2600x Switch's name but not the IP address
