Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Doing the basic lab.I'm able to print table for the network devices with hostname type UUID etc.now I want to select a particular host from the table and print the config of that host.the logic I'm trying to understand is , how do I get the "ID" para...
I'm beginner and trying to write python to understand this more. if I remove the # from print I can see the nice long out put and I want to further code it to get only few items from that output. When I run this code I get error "TypeError: string in...
I've follow up question on this lab.can you explain the logic used to display the correct "id" in the url ?How does every time its able to pull the right UUID to display the correct config.I'm not able to decode this code even though its working fine...
Yup.. works, thanks !, I was too hesitate to run the code by stressing too much that it would not work because does not look like valid URL but seems like it is absolutely fine to pass variable in the url..:|:.:|:.CISCO Lalit Gupta | Systems Engine...
Thank you, Yawchen. It was very helpful..:|:.:|:.CISCO Lalit Gupta | Systems Engineer - Sales| Single # Reach: +1 408 895 8379 | lagupta@cisco.com<mailto:lagupta@cisco.com>
