Hi All, I have merged some zones on creating ISLs. When I am in fabric manager on VSAN10 I can see the zones, when I go to edit the Zone database the zones are not there??Any ideas??
Many thanks to Steven & Hershal06..I'll try to enable Full Distribution, and copying active zonesets...May have to log a call with Cisco..?I'll let you know how I get on..Many thanks again..Dave
Hi Hershal06, Thanks for the reply.. Yes, I have tried all switches in the drop down and all VSANs?I am not at work untill later.When I get there I'll upload some screen shots to show you what I see in the main fabric manager wind...
Hi Steven, Again, thanks for your assistance..The screen shot was from the original switch..I have 7 switches in each fabric, but everything was OK until I added these screen shots from these 2 switches (that i have attached()..CheersDa...
Many thanks again for your reply Steven,Yes, I'm afraid it is production..I have a few VSANs and also have IVR, but it is vsan10 that the zone seem to have vanished from.I couldn't run: sh zone status vsan 10So I ran: sh zone statusI have attache...
Hi Steven,On the Original Switch I get:Full Zoning Database :Zonesets:0 Zones:0 Aliases: 8On the new switch I get:Full Zoning Database :Zonesets:0 Zones:0 Aliases: 8Cannot understand why the zones are visible in the main fabric manager window t...