Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is this normal to see after a boot of the 5512-X ? It is the very last message I am seeing on the console following boot of a brand new unit.Warning: partition table exists on the storage device (sn: XXXXXXXXXX)but may be lost or meaningless after c...
I have a customer with an ASA5505 - base license and 50 user limit.They have been hitting the limit and users are unable to get outbound through the ASA.When I run SH local-host , I only see 21 local hosts listed on the inside interface but it clai...
Looke to me like this is normal behavior and simply "cosmetic" as stated above. SSD is warning user that the disk is already formatted, in this case the software CX module was present on the drive.
Last night I ran "Clear Xlate" and "Clear Local-hosts All" and then checked "sh local". At that time the Current Host Count was 14 and the number of IPs listed in the output matched.I just checked again this morning and the host count is now liste...
