Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have recent upgraded our firewall from a Borderware Steelgate v7.1 platform to a Cisco ASA 5520 platform. Needless to say, the interface on the Cisco platform is much more complex, and I don't have much experience with Firewalls (so please t...
Sorry I haven't posted recently, but I have been in training this week and out of the office for next week. But my co-worker will be working on this issue and he can post the results you were looking for in this thread in order to get this running....
I'm sorry, I gave you some wrong information there. I checked the device setup and the External port IP is set to XXX.XXX.XXX.XX2. This is verified because when I try to set my NAT rule to use IP address XXX.XXX.XXX.XX2, it replies back with an err...
No luck, still the same situation. In the NAT rule, I've switched the original port to 443 (https) and the translated port to 82. For the access rule, I've changed the service to tcp/82 and the destination to our External Network (which has a 255.2...
This is where is gets a little confusing for me. I am currently using the Cisco ASDM 6.2, which is a GUI system.I can tell you what I have done so far;- I've created a IPv4 Network Object using the webmail's IP address and 255.255.255.255 subnet.- I'...
