Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
In cisco FWSM 3.1, you can not delete anything on the flash: partition (for example I want to delete asdm by typing "delete flash:asdm" )In cisco manual its mentioned that you can delete any file on the flash but if you check from any FWSM with 3.1 y...
I'm facing an issue with FWSM 3.1(3) when commiting an access-list. The problem is that I wont be able to connect to any server on the DMZ area unless I reset the FWSM.Any clue
I'm not able to do any more Database Pruning after I upgraded to VMS 2.3. When I create a databse rule, I don't see any scripts on the scripts list except "legacyif.pl". also when I go to the script folders I see only the "legacyif.pl"...Any clue?
Hi, I can't see "Unknown Devices" in Topology Services after I upgraded from LMS2.2 to LMS 2.5 !!!. I still have those devices in "Devices Management Database" but they are not showing in Topology Services.Is this a new feature or its configuration i...
Hi I have FWSM configured in a 6500 chassis. The MSFC is logically installed before the FWSM which means the firewall is the one connected to the internet. I have only one VLAN shared between the MSFC and the FWSM. The problem is that the FWSM can re...
no they don't but I have other devices (like servers) which don;t support CDP and they are showing on Topology Services. So the problem is not CDP, the problem is that the new topology services in LMS2.5 only shows Devices which are "supported" , oth...
Thanks for your reply, Anyways, those are non-cisco devices. I know that Ciscoworks supports only cisco devices but atleast on LMS2.2 I was able to see the status of these devices in Topology services (status=green if available, red if not responding...
