Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have an ACE module running virtual contexts. I have configured the ACE contexts to authenticate against a RADIUS server (Windows IAS).When I log in, I am always given the role of 'network-monitoring'. I would like to configure the RADIUS server ...
Hi,I have implemented multiple virtual contexts on an FWSM. I have a network for FW context mgmt connected to a vrf which then connects to another FW context providing connectivity to the rest of the network. Configuration is detailed as follows (wit...
Hi,I have implemented a set of redundant ACE modules in Cat 6513s running virtual contexts. I was informed by the Notes administrators that they are only capable of POSTing 10MB through the ACE. I have checked and there seem to be no commands or para...
Hi Roble,That makes sense. I will configure the other contexts aswell.By the way, I noticed you have some 6513s using the RADIUS server with the same settings. I also have some 6513s and 6509s. I have configured them as follows:-aaa new-modelaaa grou...
Hi Roble,I have been able to get Admin level role but it seems it only works with the Admin context and non of the others. Is this normal?Kind regards,Khalid
Hi Roble,I really appreciate your response. I have a feeling it'll work once I have modified my configuration to be on the same line as yours.I will update you on the results (fingers crossed) once I have made the changes and tested them tomorrow.Kin...
Please find attached the config of FW4.There are two 6513s each with an FWSM and ACE.I have set up Vlan5 on both of these switches with the configuration below.Switch 1:-interface Vlan5 ip address 192.168.1.51 255.255.255.248 no shutdownip route 0.0....
Hi,Sorry about the delay in responding.I have been able to get the RADIUS, SYSLOG and SNMP to work now. The strange thing is there are no packets seen in the captures I set up on the Vlan1 and Vlan3 interfaces of FW4. I have removed the nat-control l...
