About twhitney

twhitney · 01-23-2020

Hi Everyone, I have a natted Internal Webserver, which is working thanks to the guidelines found herehttps://community.cisco.com/t5/firepower/acl-to-publish-my-internal-website-help-please/m-p/4016305#M16461 Now how do I force that same server to se...

twhitney · 01-21-2020

Hi Everyone, I have scoured the web and have nearly mirrored the setup as outlined here:https://community.cisco.com/t5/firepower/firepower-publish-internal-webserver/td-p/3672845 While following the guidelines for CISCO NAT rules. NAT works as expect...

twhitney · 02-13-2020

I had this working until I added an IPSEC tunnel. Now Outbound binding an IP address to the server works but inbound External IP to the inbound server fails. Show nat has this: show nat Manual NAT Policies (Section 1)1 (dmz) to (outside) source stat...

twhitney · 01-24-2020

Thank you both, Both solutions work. I really do appreciate the help.

twhitney · 01-22-2020

Thank you for the advice RJI, I did as you suggested and edited the rule as shown. The trace comes back as follows. However, unless I switch the default access control to allow, this does not work.

Member Since	‎01-21-2020 12:16 PM
Date Last Visited	‎02-21-2020 05:41 AM
Posts	5

User Statistics

User Activity

How do I force an internal host or network to use a specific ip address on outbound http requests

ACL to Publish my internal website help - please?

Re: ACL to Publish my internal website help - please?

Re: How do I force an internal host or network to use a specific ip address on outbound http requests

Re: ACL to Publish my internal website help - please?