Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I'm using the RV340 and our LAN has a second subnet. The hierarchy looks something like this: Internet WANRV340 ( 192.168.15.1 )192.168.15.0/24 LAN 1Gateway ( 192.168.15.2 / 172.16.1.1 )172.16.1.0/24 LAN 2 The RV340 has a static route to forward a...
Hi,I'm using an RV340 router. Can I push a state route to computers on the LAN? It seems like DHCP option 121 would do that but I don't see that available on my router.
Hi, I'm using the RV340 router. I'm wondering if it works to use LAG1 with a dumb switch. What does LAG1 actually do? How does it aggregate the connection? Thanks!
It might make sense. I have to consider my approach because maybe I am overlooking something simple. Here is the topology:[ LAN 200 ] --- [ Gateway GW2 ] --- [ LAN 100 ] --- [ RV340 ] The second LAN is behind GW2, which has a firewall. So, I want the...
Here is an example: The RV340 DHCP is set up to give out addresses for 192.168.100.0/24 (network A). I have another network (network B), using 192.168.200.0/24. I set up a gateway on network A with the address 192.168.100.200. The clients on network ...
@balaji.bandi wrote:RV Model does not support LACP, it supports static(not dynamic) link aggregation with Trunk option with the neighbor device/Switch. Also, is it layer 2 (based on MAC addresses)? Layer 3? Both?Thanks.
@balaji.bandi wrote:RV Model does not support LACP, it supports static(not dynamic) link aggregation with Trunk option with the neighbor device/Switch. So, to clarify, this is not a fallback solution (passive) but an "active" bond where the ports are...
Thanks. This is an area where the documentation could use improvement. It says almost nothing about this feature and it would be helpful to understand.
