So i'm trying to make a simple router on stick network to route vlans that i have in my network like below  i have configured it on packet tracer and it works, i can ping the pc's between vlan 30 and 20, so i did the same configuration on my rea... view more

Morning: I'm new to the world of Cisco Packet tracer, and I am creating a network for a uni project. So far, what I have is: 5 VLANs (subnetted to 192.168.2.0/26, 192.168.3.0/36 etc) All are connected to ports Gig 1/0/2 - 1/0/6 on a 3650 sw... view more

Sir, I'm asking about host table configured in router. I studied that host table in router is an alternative for dns server. I configured host table in my router in packet tracer. The problem is i cannott ping pc to pc by name. But i can ping from router ... view more

Good morning! So I'm a serious newbie and I built this network in packet tracer. I have three routers (all with peer-to-peer connections), each representing a different location, and four switches attached to each router. I also have one additional r... view more

Hi I have a problem to configure C-890-k9 switch – I mean to make  acces user connected to Fa 1 port to the  internet.I was trying to connect on Cisco Packet tracer and connection pass. ButWhen I’m trying to configure in real  switch “C-890... view more