Forwarding Table

[Ziad El Achkouty]

How to check the forwarding table on a leaf in apic cli

[sateeshk10]

you can go thorugh below link for more commands on ACI which covers fwd table commands.

https://supportforums.cisco.com/document/12268026/cisco-aci-cli-commands-cheat-sheet

Regards

Sateesh K

[Ziad El Achkouty]

Can you please specify which commands show the forwarding table? I can't seem to find them

[sateeshk10]

I guess all NS related commands are specific to forwarding engine because NFE uses for forwarding in 9k`s.

endpoint commands are good to know fwd stuff.

show endpoint ??/show ip endpoint...!!

Regards

Sateesh K

[micgarc2]

to show the end points learned locally (direct attached to the leaf) use:

#show endpoint

to see packets originating from the fabric when ingress is specified:

#vsh_lc

#show platform internal ns forwarding lst-12 ingress

to see packets originating from the front panel when egress is specified:

#vsh_lc

#show platform internal ns forwarding lst-12 egress

Hope this helps,

Michael G.