ANM VA - run perl script to obtain and genarate reports.
We have a customer who has an ANM deployment at a site. This is a HA deployment on RedHat. The customer created a perl script to run off an external host to generate reports. This was acheievd by querying the sqldatabase (dcm_ems). ANM version is 3.2. No problems.
An additional ANM deployment was done on another site. ANM version 4.2. This deployment is the VA edition. They would like to deploy and run the same perl script.
Is this possible on the VA Edition? Even with the RootPatch? Not sure of the level of access the patch provides, or if it is even recommened or would then still allow for the ANM to be supported? If possible, has the sqldatabase structure changed (suppose would need this for the guy's to ammend the script)? How would we obtain the "sqluser" and "sqlpwd" info for the perl script to use?
In the previous article, we have seen, how to assign IP Address to Cisco UCS Management Interface. This way we gain access to the on-board management software called Cisco Integrated Management Controller (CIMC).
The next step of building UCS Server ...
How does everyone feel about service graphs in a brownfield network centric cutover? maybe I'm an old school engineer but I was taught that if you have to do a Pbr then your design is wrong. they are a pain to troubleshoot because you always f...
To participate in this event, please use the button to ask your questions
This special event - formerly known as Ask the Expert- is open only to Cisco Customers and Partners.
Many pages in the Cisco Community are acce...
Going to Cisco LIVE EMEAR 2020? Give your Data Center agenda a boost with these top recommended sessions. Register and join us!
Data Center Networking:
From Reactive to Proactive NetOps With Cisco Network Assurance and Insights- The Power of Data...