ISR-WAAS with two routers

[kunze_m]

Hello!

Is it possible to have two Routers (one with ISR-WAAS, one without) at a remote site so that the router without ISR-WAAS uses the ISR-WAAS of the other router? (In the CVD I only finddual router with dual ISR-WAAS).

Regards

Michael

[finn.poulsen · Accepted solution]

Hi Michael,

Yes it is possible.

However the redirection method depends on what kind of router the one without ISR-WAAS is :

another ISR-4000 :

You can use AppNav (both routers in the same Application Controller Groups & the ISR-WAAS as only member af the WNG/Waas Node Group).

almost any other router :

You can use WCCP on both routers redirecting to the ISR-WAAS.

Best Regards

Finn

[kunze_m]

Thank you very much. In most case the other Router will be a CISCO800 to connect a DSL line.

Is there a sample configuration available how to use ISR WAAS with WCCP?

Best regards

Michael

[finn.poulsen]

Hi Michael,

Apparently I have misinformed you.

WCCP is not supported on ISR-WAAS - only APPNAV-XE.

See BUG CSCva69516 for description.

Sorry

Finn