Hi guys,
Just wondering if you have experienced this issue somewhere else and if you have any resolution to it? We are currently trying to monitor 2 x WAE-694-K9 in our data centre via SNMP. 1 of them works, the other doesn't.
WAE-01 does not work and what we see:
* CPU utilization is around 13% and this will drop to 1% if we remove the snmp community configuration. When we add back the snmp community, the snmpwalk is responsive once but after a while it will go back to 13% and the snmp is no longer responsive.
* We did a packet capture and we are seeing the SNMP request coming to the WAE via the correct interface. There is no reply from the WAE.
* The CLI respond is quite sluggish, for example when we execute the 'show run', it takes approximately 8-10 seconds for the first line to appear and when we do a 'term len 0' before the show run, the config appears line by line with about 1 sec delay in between. The initial delay happens for all commands, not just 'show run'. We suspect this is related to the CPU utilization of 13% that we see in this WAE.
WAE-02 works and what we see:
* CPU utilization is around 1%.
* We did a packet capture and we are seeing both SNMP request and respond.
* The CLI respond is not sluggish.
SNMP Configuration between the two WAE are exactly the same.
Saw this bug CSCsm28839 but both WAEs are being monitored by two servers.
