1. ] When using the setup wizard the first choice is greyed out at DHCP for WAN connection. I cannot make an additional choice. I also cannot choose a VLAN or make any changes regarding this. It would seem that if all options are greyed out then they shouldn't be part of the wizard.
2.] When completing the wizard it turns out the DHCP option was NOT chosen for WAN0 but instead for WAN1 even though the wizard specifically stated WAN0 was DHCP.
3.] When configuring port forwarding why is there not an option to choose "ANY" or 2 of three WAN interfaces for port forwarding to work on? What if one interface is down and/or I would like services to come in on either service?
4.] Aside from the grammatical/spelling error in the message, "Do no duplicate the remote access port." why can I not forward http (80) to an internal device? In remote management settings all remote access whether through port 80 or 443 is disabled so there should be no reason I cannot use port 80 for an internal server.
5.] I also concur with the other commenter about the 100Base-T LAN ports. It seems as if it should at least be the other way around with the WAN ports at 100Base-T and the LAN ports at gigabit but today all of them should be gigabit. I also agree about the chassis.
I'll post more when I have more time to test and move through this. So far we haven't put this into active use because without the forwarding issue fixed it cannot go into "production" for better testing. Thanks!
