Is there a fix or workaround for this soon?
Forum Posts
We recently upgraded to 17.15.4 throughout our hospital. This was done after a Cisco bug scrub and recommendation. We are now experiencing this type of reload on multiple switches due to this. Yes, they recover but this is not acceptable in a cr...
Cisco ASR 9906, IOS-XR version 25.2.2, with the below configuration:--------------------------------------------------------------------------------0/RSP0/CPU0 A9K-RSP880-LT-TR(Active) IOS XR RUN NSHUT0/RSP1/CPU0 A9K-RSP880-LT-TR(Standby) IOS XR RUN ...
Bug shows status fixed, but no fixed version is mentioned. please update.
IOSXE：17.18.4(MD)を採用しておりが、Cisco Download Centerでは OSXE：17.15.5が推奨となってます。推奨バージョンであればBUGが解消されているのでしょうか？
Does anyone NOT have this issue? run# sh system resources I have 6 CPU's pegged because of it.
For everyone who stumbles upon this defect - I believe there's a missing step that is not mentioned in the workaround. I doubt that it is just a coincidence, as this happened to me twice in a year.Following the steps I have re-registered the UCCX clu...
Could you please confirm whether ACME support for CUBE is currently on the roadmap or backlog? If so, do you have an ETA or approximate timeframe we could share with our customers?This is becoming a critical point for us: customers using MS Teams Dir...
Background (from the SR) - at least I had the same issue:A switch or router with IP routing disabled creates an IP ARP entry for a TFTP server's IP address that is not in it's local management IP subnet when running a TFTP transfer. The MAC address i...
Same logs, But the Other side is connect with the Acces Points, instead of C8200. Logs are similar which are seen for C8200 conection as mentioned in this Bug id.
Hi Cisco Team,This is a critical bug that is severely impacting our environment. The Zone-Based Firewall (ZBFW) is silently dropping traffic without inspecting it and without generating logs.Because it fails silently, it makes troubleshooting nearly ...
Hifor some reason it does not work for my syslogserver even with the recommended settingsI am running 10.5(4), NX9KLogging settings as per CSCvv82909 - `login on-success log` does nothing at `logging level authpriv 3` or higher# sh run | i loglogging...
When upgrading from 7.2.5 to 7.2.7 this bug is also occurring. I have two TAC cases open prior to finding the error message and this documented bug, so we'll see if I get a response.
PSA for anyone experiencing this bug.Our specific symptom is that SGTs are no longer detected by the FTDs, this is because ISE can no longer match the ip to the SGT, as it's being lost somewhere between the switch sending it to ISE. IP appears fine i...
It may be just me, however it looks like the whole bug description, etc was written by a third grade student.If someone can re-write this to be more readable and comprehensible, it would be greatly appreciated.If you need to use AI, pls do so.
