Hi, a Cisco Nexus 3548XL was running 9.3(10) with PTP and there was no issue synchronizing with the grandmaster clock. When issuing the command "show ptp clock", the PTP clock status shows "locked". There is also a downstream switch and showing its P...
Forum Posts
FYI for everyone who attempts Workaround 1!:At least when I attempted the workaround, I had to stop and start netconf twice before it was working again.the first time I restarted the service, it got stuck at init:After the second restart it initially...
We are getting the below error at vEdge-1000 WAN router however there was no power outage at site.RTC reports PWRFAIL @ 11:39 on 07/06, powered up again at 09:44 on 08/06What is the solution for this error. this is affecting the Guest wireless servic...
Hifor some reason it does not work for my syslogserver even with the recommended settingsI am running 10.5(4), NX9KLogging settings as per CSCvv82909 - `login on-success log` does nothing at `logging level authpriv 3` or higher# sh run | i loglogging...
Looks like we hit the same on 16.1(5e).
Fighting this issue for a while.vEdge 100m 20.6.6, -GB modem (mc7304), 5.5.58 firmware, modem gets dhcp in 'show cellular sessions' yet cellular0 fails to get ip address (logs show dhcp timeout -> connect retry perpetually).Profile is correct, sim ca...
We have recently noticed the following syslogs across all of our SPGW nodes:May 22 16:49:24 x.x.x.x evlogd: [local-60sec24.860] [gtpumgr 157282 error] [1/0/8387 <gtpumgr:3> gtpumgr_proc.c:1648] [context: spgw_ctx] [software internal system syslog] Me...
what is the plan for fixing this counter reporting problem ? vlan counters reporting the uni/multicast counters but its not per interface based.
Hi Cisco Team,This is a critical bug that is severely impacting our environment. The Zone-Based Firewall (ZBFW) is silently dropping traffic without inspecting it and without generating logs.Because it fails silently, it makes troubleshooting nearly ...
Seeing this error on my ISR router%DUAL-5-NBRCHANGE: EIGRP-IPv4 500: Neighbor 10.254.61.1 (Tunnel1220) is up: new adjacency003318: May 19 12:57:45 UTC: %DUAL-5-NBRCHANGE: EIGRP-IPv4 500: Neighbor 10.254.61.1 (Tunnel1220) is down: holding time expired...
Also seen on IE9320-26S2C running 17.12.4 (factory default).This took more amount of time to troubleshoot than should be necessary in 2026..
Dear Cisco Team,I just wanted to say thanks and I can confirm the fix is working with 26.1.1.We tested the function with a C8130-G2 and it is working fine now. So far we could not find anything that was not working. We will perform additional tests w...
sadly this issue is arround for almost 9 months without beeing fixed in 15.5.When is this going to be fixed?!
Has 26.4 and up fixed this for others?Thanks!
Workaround: Apply the wired/application QoS policy using match protocol classifications first, then apply the wireless/application QoS policy using match protocol attribute classifications. The issue appears to be triggered by the deployment order wh...
