does anyone know why the device-sensor accounting command was removed from the 15.0(2) train for catalyst 2000 switches? just updated a few 2960S switches to 15.0(2a)SE9 and suddenly i'm not getting my CDP information sent in my radius device tracking to ISE for Cisco Phone profiling!
the bug notes a workaround but i cannot figure out how to apply it:
1. Asset Recovery EMEAR - Scope2. Cisco Returns Portal – Quick Overview3. Update your RMA – Options and Walkthrough4. POWR Tool and How to Return - Quick guide and Scenarios5. Returned but not closed - Frequent Scenarios6. I cannot return my faulty part. ...
Full analysis if the problem
The root cause behind this problem is the delay in sync between CUCM and CCX.
CCX and CUCM has an automated sync mechanism which might vary from 5 - 10 minutes based on various parameters.
Also there is an option to sync...
1. Asset Recovery EMEAR - Scope· Supporting faulty Service RMA returns· Providing and creating Outstanding Open RMA reports to partners· Handling invoice creation for non-returns· Initiating Certificates of Destruction for parts containing security data· ...