I am writing to seek your expert assistance regarding an issue I am encountering with my Firepower model FPR-2110 . The unit is currently running Boot Loader version 1.0.12 and System version 2.6(1.198).
The problem I am facing pertains to the inability to execute certain command line interface (CLI) changes on the device. Specifically, I am unable to use the "set out-bound" command to modify the outbound IP address, and I'm also facing difficulties when attempting to add HTTP or SSH IP addresses. These limitations are significantly affecting my ability to manage the device effectively and configure it according to our requirements.
I have performed due diligence in troubleshooting, including reviewing the configuration and consulting relevant resources, but the issue persists. Given the importance of these changes for our network operations, I am reaching out to your esteemed team for guidance and support in resolving this matter.
I kindly request your expertise in diagnosing and rectifying this situation.
