Cisco Modeling Labs Documents

Hi,  I'm relatively new to setting up simulations as I'm a junior network engineer on university placement.  Can someone guide me if even possible on how and where to install a CML environment on a online provider. My company and I use... view more

I have a bare metal install of CML2.  I've noticed when running a lab with XRv9000 nodes in it, they will, after a time, stop responding.  When it happens, the cpu usage on that node goes to zero.  And the node cannot be stopped, or turned ... view more

I am just starting with CML, installed 2.1.2 controller and created a 10 node IOSv simulation on a ESX VM with 12 vCPUs.  Everything was OK until I implemented a udp-jitter sla test (only running once every 2 minutes) on one node, and now that node i... view more

Hello, I´ve followed the following instructions for setting up MGMT-access directly towards the hosts in my network-simulation https://developer.cisco.com/docs/modeling-labs/#!external-connectivity-for-simulationsExternal-connector is configured... view more

New to this forum, and have been directed here by CLNS support. I have a problem whereby CML fails to install on Dell R610 which previously ran VIRL no problem.  Screen shots attached. Stops at "Reached Target Basic System", then pauses for a fe... view more