First timer on CML - setup error

[Mark Kwan]

Hi everybody, wondering if I can get some info here.

Found some online info on how to try to get a 4 hour CML session so anxious to try out.  Logged in,  reserved session, setup started but  didn't look good...  Is this 'free' online CML thing worth the effort ?

OUTPUT

18:56:47 Environment Driver Setup has begun

Beginning sandbox setupPreparing connectivityApps deployment startedApps are being discovered...Connecting all appsApps are powering on...Waiting for apps IP addresses, this may take a while...No apps to configureSandbox setup finished successfully18:59:22 Just a moment - a few more things left to setup...

18:59:28 Setting POD Internet access policy

18:59:30 Waiting 4 minutes for all systems be become fully ready

19:03:30 Calling Setup on applicable resources

19:04:45 Beginning Setup for resource [Cisco Modeling Labs_35f5-b055]

19:21:47 -xxxxxxx  had to remove this item.

19:20:54

ERROR detected when calling Resource Driver Command [Setup] for resource [Cisco Modeling Labs_35f5-b055].
Friendly Error Message: CML Setup Error from Resource:Cisco Modeling Labs_35f5-b055
Technical Error Message: BID/start -H "Authorization: Bearer $VIRL_TOKEN"_LA
{
"description": "Licensing issue: System is not licensed.",
"code": 400
}[At Address:10.10.20.161
Error Location: UDC_RD_NSO_VIRLLicenseVIRL


19:21:03 None

19:21:03 Errors occurred preparing environment. Please use the forum at
https://communities.cisco.com/community/developer/sandbox for assistance

19:21:03 Driver Complete.

Thanks all

[bigevilbeard]

@Mark Kwan  the ENG team are working on an issue with this sandbox. It has for now been taken out of the catalog. Please check back later and this should be good to go!