Prefix list filter in BGP

[gabriel.lima.caitano]

Hello guys, everthing good ?

I'm trying to implement a filter on the BGP prefix list.

R1#show bgp ipv6 unicast
BGP table version is 3, local router ID is 1.1.1.1
Status codes: s suppressed, d damped, h history, * valid, > best, i - internal,
r RIB-failure, S Stale
Origin codes: i - IGP, e - EGP, ? - incomplete

Network Next Hop Metric LocPrf Weight Path
*> 3000::/64 3000::2 0 0 200 i
*> 5000::1/128 3000::2 0 0 200 i
R1#

Even after putting the prefix-list it doesn't work ::((

R1#show run | s prefix
neighbor 3000::2 prefix-list rede in
ipv6 prefix-list rede seq 5 deny 5000::1/128

this 5000::1/128 network is a loopback that is coming from my R2, but the filter doesn't work, someone could help me, I can't see why not work... ::((

[Jaderson Pessoa · Accepted solution]

Hello my friend,

i've answered your doubt in your other post:
https://community.cisco.com/t5/discuss%C3%B5es-routing-switching/prefix-list-ipv6/m-p/4569316

Regards,

Jaderson Pessoa

[gabriel.lima.caitano · Accepted solution]

Thanks budy!! :::))

[Jaderson Pessoa · Accepted solution]

Thank you!

Obrigado!

You're welcome to Cisco Portuguese Community!

Seja bem vindo a comunidade portugues da Cisco.

Abraços,

Jaderson Pessoa