GigabitEthernet1/1 and GigabitEthernet1/2 there are both outside interfaces
Third, I went to Devices - FlexConfig - Create a new policy for my device and added two previously created FlexConfigs to it. Deploy configuration.
Next, I have changed metrics to 1 for two default routes attached to these interfaces. Deploy configuration again.
Also, I have created two SLA timers (Objects - Object Management - SLA timer) and attached them to these routes. I don't know if it important or not, but it helps me keep both routes in running-configuration (without second SLA timer only one route appears)
Setting up some 3rd party devices for my Fire and Rescue trucks that will VPN back to our FPR-2110. I can blatantly see what's going on with the IKEv2 platform and protocol debugs on. It's selecting the wrong dynamic map!IKEv2-PLAT-4: (32): Cry...
On January 22, 2020, the Cisco Product Security Incident Response Team (PSIRT) disclosed a vulnerability in the web-based management interface of Cisco Firepower Management Center (FMC). The vulnerability could allow an unauthenticated, remote attac...
Meet the Authors Event - A Cybersecurity Deep Dive with Omar Santos
(Live event – Thursday, January 23rd, 2020 at 10:00 a.m. Pacific / 1:00 p.m. Eastern / 7:00 p.m. Paris)
This event will have place on Thursday 23rd, January 2020 at 10hrs PDT
Posting this for anyone interested in using a Raspberry PI as a flow collector for Stealthwatch. We created a very lightweight version of our software. It can create flows if the eth port is attached to a SPAN or you can forward NetFlow/IPFIX ...