I sometimes end in a situation where a flow of jobs are "out of sync" - meaning that they normally run sequentally and therefore always have similar instance numbers. They have dependencies based on "Match Occurrence" - for many reasons.
But if they get out of sync, I can't find a way to align instance numbers again. I need a way to remove un-completed jobs, to get back so I can start with instance # 1 again.
In the previous article, we have seen, how to assign IP Address to Cisco UCS Management Interface. This way we gain access to the on-board management software called Cisco Integrated Management Controller (CIMC).
The next step of building UCS Server ...
How does everyone feel about service graphs in a brownfield network centric cutover? maybe I'm an old school engineer but I was taught that if you have to do a Pbr then your design is wrong. they are a pain to troubleshoot because you always f...
To participate in this event, please use the button to ask your questions
This special event - formerly known as Ask the Expert- is open only to Cisco Customers and Partners.
Many pages in the Cisco Community are acce...
Going to Cisco LIVE EMEAR 2020? Give your Data Center agenda a boost with these top recommended sessions. Register and join us!
Data Center Networking:
From Reactive to Proactive NetOps With Cisco Network Assurance and Insights- The Power of Data...