11-20-2013 01:33 AM - edited 03-10-2019 06:05 AM
I currently have a cisco ASA 5512 with IPS.
I have eth0 connected to my WAN
eth1 connected to my LAN ( Switch ) 10.0.0.254
I have setup my sensor on 10.0.0.253 which seems to be on the management interface?
Currently i don't use the managment interface for anything but now i have configured this will i have to plug the management interface into my lan?
just confused to how it will check the trafffic as anything coming from the outside ( internet ) wll go via eth0 which goes to eth1 internal?
Don't understand how the management interface will be able to check against attacks? obviously i will be using inline mode.
Thanks
11-20-2013 02:29 AM
just to add on the cisco IDM interface is shows Management0/0 assigned virtual sesnor 0 NONE
Then i have portchannel0/0 backplane interface that is assigned virtual sensor 0 VS0
11-20-2013 03:58 AM
ok think i have anwsered my own question.
the management0/0 is just simply i was of giving me access to the IDS. the actual sensor maps to port channel0/0 (backplane) so anything go through the ASA will go via the sensor.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide