cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1274
Views
15
Helpful
3
Replies

Algosec user authentication with cisco ISE

Wajih1
Level 1
Level 1

Hi Guys,

 

I'm now integrating Algosec Solution with Cisco ISE radius server for user authentication (web Access). I didn't find the dedicated VSA for that in cisco ISE. Any one has already configured the same thing ? 

 

thanks for your help ! 

 

regards,

3 Replies 3

@Wajih1 algosec supports RADIUS so it will work without vendor specific attributes

 

Just configure algosec to authenticate to ISE RADIUS server and setup in ISE as a network device with the shared secret.

https://www.algosec.com/docs/en/asms/a30.00/asms-help/content/afa-admin/configuring-user-authentication.htm

 

Thanks for pour Replay !

 

Yes, i Know that Algosec support radius authentication, but i'm asking about Cisco ise policies configuration for Algosec Access. 

anli
Level 1
Level 1

For anyone struggling with this. On ISE you just set a typical ACCESS PERMIT, no special Attributes needed. What I found in the Algosec documentation that they dont clearly specify, is that you need to add each user that you want to allow via Radius as a User on the Algosec UI and check the "RADIUS Login" checkbox and give them the proper access. 

Review Cisco Networking for a $25 gift card