cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
362
Views
0
Helpful
2
Replies

ASA 5520 Configuration Issue

s.mazumdar
Beginner
Beginner

Hi,

My simplified network diagram is attached.

I want access from Site A to site B and vice versa through my ASA.

Both the sites are on the outside interface of ASA. Instead of doing subinterface of the outside is it possible to configure the required routing?

Thanks in adv.

1 Accepted Solution

Accepted Solutions

didyap
Frequent Contributor
Frequent Contributor

In the diagram, site A, site B and the ASA are connected to each other via a L2 switch. In such a case you will not need any routing to be configured on ASA so that the traffic can flow between site A and site B. Although you will need routing to be configured on the end routers.

View solution in original post

2 Replies 2

didyap
Frequent Contributor
Frequent Contributor

In the diagram, site A, site B and the ASA are connected to each other via a L2 switch. In such a case you will not need any routing to be configured on ASA so that the traffic can flow between site A and site B. Although you will need routing to be configured on the end routers.

thanks

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: