ASA5506W-X - wifi problem

[erik bakke]

Hi!

I have a new 5506W-X (wifi model).
I have problem accessing the wifi setup, ref to the quick-quide:

 On the computer connected to the ASA inside network, launch a web browser.

2. In the Address field, enter http://192.168.10.2. You are prompted for the username and password.

3. Enter the username Cisco and the password Cisco. The access point GUI appears.

But i`m unable to open 192.168.10.2 or ping the ip.

I can see the interface 1/9 is up with 192.168.10.1 (asa ip) and dhcp enabled with range 192.168.10.2-200

Cannot find any config for ip 192.168.10.2

Config guide for 5506 has no more info regarding wifi setup.

Any tips?

Regards

Erik

[Akshay Rastogi]

Hi Erik,

As per your description, i could see that the ASA is configured with DHCP range 192.168.10.2-200. Therefore your access-point has received IP address from DHCP. 

As you have mentioned that your computer is connected to ASA inside interface network(expecting that PC is getting IP in range 192.168.10.x), i expect the traffic to directly go to 192.168.10.2 without going through ASA.

Please check if the your access-point is configured correctly. or If you need to access it through 'https instead of http'.

Please let me know if you have any query on this.

Regards.

Akshay Rastogi

[ACS-rider]

Not able to access the 192.168.10.2 URL -- Does anybody have the right information?  could we get set up via command instructions?

[Flavio Miranda]

Hi @erik bakke

Run the command "hw-module module wlan recover configuration"

Try again and let me know.

-If I helped you somehow, please, rate it as useful.-