Hi eveyone,
Now ASA with Firepower is setting.
Firepower status is up from command "show module sfr detail".
ASA# show module sfr details
Getting details from the Service Module, please wait...
Card Type: FirePOWER Services Software Module
Model: ASA5506
Hardware version: N/A
Serial Number: ＊＊＊＊
Firmware version: N/A
Software version: 6.0.0-1005
MAC Address Range: cc46.d615.24e6 to cc46.d615.24e6
App. name: ASA FirePOWER
App. Status: Up
App. Status Desc: Normal Operation
App. version: 6.0.0-1005
Data Plane Status: Up
Console session: Ready
Status: Up
DC addr: No DC Configured
Mgmt IP addr: 192.168.1.2
Mgmt Network mask: 255.255.255.0
Mgmt Gateway: 192.168.1.1
Mgmt web ports: 443
Mgmt TLS enabled: true
The problem is below.
(1) Firepower Mgmt IP cannot return ping.
ASA# ping 192.168.1.2
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 192.168.1.2, timeout is 2 seconds:
?????
Success rate is 0 percent (0/5)
ASA# ping 192.168.1.1
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 192.168.1.1, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/1 ms
(2) ASDM does not recognize Firepower.
When trying to register Firepower, an error window is displayed
---messages---
Cannot connect to the ASA FirePOWER module. Check that it is correctly configured and on the network.
It is also possible that the management address is being translated by NAT.
Please verify the IP address/Hostname and port.
Please Help me.
