We are running a ASA5520 with system image of "disk0:/asa843-k8.bin". I'm also running ASDM ver: 6.4(7).
So my question is while I'm in the ASDM on the configuration of the firewall, I'm looking at the Access Rules. When I do a show log on any of the rules that have hit counts on them, it opens up a Real-Time Log Viewer but I don't see any information. It's not showing anything, nothing appears, it just sit's there like it's waiting but no data is coming. Even though if I go back out to all the rules, I can see the hit count incrementing. The same thing happens no matter which rule I pick with hit counts on them.
I'm hoping in the end I can click on show log on the rule in question and see each individual hit information Source/Destination IP, Srce/Dest Port, Severity, Date and time.
I'm sure it's just a configuration issue I'm missing somewhere but I can't seem to figure it out. Any help with this issue would be greatly appreciated.
Please note that the minimum cryptography settings in AnyConnect 4.9 have been increased. Please ensure that your head-end is properly configured for the more stringent cryptography settings (if applicable) or users will be unable to connect after updatin...
In this guide will we be taking a look at how to configure the web.config file using the URL Rewrite tool when deploying the TETRA update server. This guide is meant as a companion to the existing guides and to help fill in some in...
Note: This guide is provided as a best effort to better help users understand the potential impact running multiple clients with TETRA, SPERO, ETHOS, DFC and SHA256 Lookups enabled and their bandwidth usage. The sizes in these guides are s...
When I log into my application, I'm suddenly asked to create a new organization. Did something change or migrate? I already had an organization.
You may be starting from security.cisco.com and mistakenly clicking "SecureX sign-on...
I followed these instructions and setup all my accounts to use SecureX sign-on, including my AMP account (my Cisco Security Account - CSA). When I use SecureX, and I click on the AMP "launch" button, I have to login again. Why?