cisco asa eigrp

[Benjamin Saito]

I am setting up a cisco asa 5515-x code version 9.3.2 and learning routes from a router via eigrp. It is establishing just fine, but there are a could routes in the static route table I need to redistribute, but not all o fthem. How do I go about redistributing only a few static routes and not all of them? I tried just adding the network statement in and that wasn't working. Thanks!

[Ganesh Hariharan · Accepted solution]

I am setting up a cisco asa 5515-x code version 9.3.2 and learning routes from a router via eigrp. It is establishing just fine, but there are a could routes in the static route table I need to redistribute, but not all o fthem. How do I go about redistributing only a few static routes and not all of them? I tried just adding the network statement in and that wasn't working. Thanks!

Hi ,

Use Route-map or Distribution list for re-distribution in EIGRP. Check out the below link for more information.

http://www.cisco.com/c/en/us/td/docs/security/asa/asa82/configuration/guide/config/route_maps.html

Hope it Helps..

-GI

Rate if it Helps..