Ciso FTD 1010 Not Pingable

[Michael-Stalker]

We are facing an issue configuring our Cisco FTD1010 firewall as a gateway for a remote site. Port 1/1 is connected to our ISP modem and receives an IP address via DHCP. Port 1/2, with an IP address of 10.0.250.2/30, acts as a router connected to our core switch, which manages all VLANs at the site. VLAN 250 uses the IP address 10.0.250.1/30, and port 1 on the switch is set to VLAN 250 access.  The core switch is the gateway for all VLANs.

I am unable to ping the firewall's interface. 

When I connect a PC to the port on the switch I can ping the gateway.  When I connect a PC to the Firewall port 1/2, I cannot ping its interface.

We are allowing ANY / ANY traffic on the inside interface and port 1/2 is the inside interface.

[MHM Cisco World]

use capture to check if interface see ping or not

MHM

[Michael-Stalker]

I do not know why this worked but we moved our inside interface from port 2 to port 3 and everything works fine.  Is there an issue with Port 2.

[MHM Cisco World]

We can't know' in window try connect to port 2 and make sure you enable it and capture traffic.

MHM