Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
3429
Views
10
Helpful
1
Replies

Command to change the IP of the firepower Module

rhussaini
Level 1
Level 1

‎04-05-2016 09:45 AM - edited ‎03-12-2019 05:57 AM

All,

What is the command to change the IP of the firepower Module after the initial install. I need to be able to chnge the IP of the builtin Mod on the 5516X. I having hardtime finding the command.

Thanks

Labels:
0 Helpful
1 Reply 1

yogdhanu
Cisco Employee
Cisco Employee

‎04-05-2016 10:05 AM

Hi

Please use " configure network ipv4 manual ipaddress subnet mask gateway"

Thanks

Yogesh

Customers Also Viewed These Support Documents
Review Cisco Networking for a $25 gift card