Configuring NAC MANAGER HA - link failure detection

[Daniel Stefani]

Hello,

I'm configuring HA in NAC Manager and want to enable "eth0 link failure detection based failover". Is this possible in version 4.1.2.1 ?

Where can i configure this in NAC Manager?

See my configurations for the Primary HA on pic attached.

kind regards,

Daniel Stefani

[Lauren Sullivan]

Hi Daniel,

It doesn't look like that's an option in the 4.1.2 line.  You can configure this in 4.1.3 line, however - see the configuration guide here: http://www.cisco.com/en/US/docs/security/nac/appliance/configuration_guide/413/cam/m_ha.html#wp1040221

HTH,

Lauren