CX module not accessible through browser..

[kaus2005007]

Guys,

I have Cisco Firewall & Firmware 9.0.1 i have installed CX module in it. Also done with partition & management ip has been assigned

But still i m unable to access it through browser.

Also i have rebooted firewall but didnt work.

Any suggestion on this ?

[Akshay Rastogi]

Hi,

Please provide the output of 'show module cx detail'. Is you management ip is in the subnet of inside 'trusted' interface. if yes, then check if the management interface and inside interface both are in the same vlan on switch.

Also check if the management interface is 'UP'. If you are accessing it from outside, then check the management ip is natted correctly.

Hope it helps.

Regards,

Akshay Rastogi