01-31-2014 10:26 AM - edited 03-11-2019 08:38 PM
Hi Everone,
When i type sh run on ASA 5520
it gives error
ERROR: Command Ignored, Configuration in progress...
Any fix other than reboot?
Regards
Mahesh
01-31-2014 10:38 AM
Hi,
Are we talking about a Failover pair or a single ASA?
I have only had this happen to me while more than one people are configuring the ASA at the same time.
Can you see any other users on the device at the moment?
show ssh sessions
show asdm sessions
Then again if this is a Multiple Context mode ASA then you would perhaps have to issue those commands on the Admin Context depending how the management connections are set up.
I would imagine though that in normal circumstances this should not be a problem for a long time.
- Jouni
01-31-2014 11:01 AM
Hi Jouni,
This is failover pair.
Single context.
Currently no one is logged in except me.
Regards
Mahesh
02-01-2014 07:22 AM
Hi Jouni,
Here is more info on the issue.
This ASA is acting as DHCP server for users.
Now it is not providing IP to the users.
Also users PC who have IP from ASA i am unable to ping their IP address.
First we thought it was bad cable from patch panel to user.
Then we unplug the failover cable from standby firewall after this i was able to run all the commands and users were
able to get the IP address from the ASA.
Seems it is synch issue between 2 ASA.
After this i put failover cable back to standby and we lost access to primary firewall and our internet was not working.
Then we shutdwon the standby ASA and reboot the Primary ASA then everything was back to normal.
Currently standby ASA is standalone and not connecting to anything.
When i power on the standby ASA all hardware looks ok and is up and running.
Regards
Mahesh
Message was edited by: mahesh parmar
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide