cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
524
Views
0
Helpful
1
Replies

Error on IDM

yusufidvi
Level 1
Level 1

I have an IDSM-2 with version

5.0(2)S152.0 on a 7600 chassis. I am unable to manage the IPS using the IDM.

When I try to log in, I get the following error

"Error connecting to sensor. Failed to load sensor-

errSystemError-ct-sensorApp.487 not responding, please check system

processes - The connect to the specified lo::ClientPipe failed

Exiting IDM"

This error comes after it loads the configuration on the IDM.

I use tcp port 443 to manage the IDSM. It was working fine earlier. This problem cropped

all of a sudden. I am able to access the IDSM on telnet.

Rgds,

1 Reply 1

smahbub
Level 6
Level 6

re-imaged the sensor to 5.0.2 and then updated to 5.0.6 then upgrade the signature

Review Cisco Networking for a $25 gift card