07-01-2010 06:18 AM - edited 03-11-2019 11:06 AM
Is possible configure fail to wire in a PIX working on Transparent firewall mode, to allow pass all the traffic in case of shutdown o reset the PIX?
Thanks
Best regards.
07-01-2010 05:32 PM
Yes, failover is possible for PIX 525 in transparent mode.
For Active/Standby failover, here is the configuration guide:
http://www.cisco.com/en/US/docs/security/asa/asa80/configuration/guide/failover.html#wp1058096
Hope that helps.
07-02-2010 12:32 AM
I want say, with a single PIX, if I turn it off or restart it, if PIX allows traffic to pass through it like a cable
Thanks
07-02-2010 01:36 AM
OK, thanks for the clarification.
The answer is no, if you reset the PIX firewall or turn it off, it will not pass any traffic at all.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide