cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1161
Views
0
Helpful
1
Replies

Firepower 7125 interface etherchannel

Sec_guy
Level 1
Level 1

Hello all,

I have the following topology and need to configure port channels between Core and firepower 7125

FMC.jpg

Could anyone help with the correct conf of the port-channel on The IPS (P1 and P3 ) through the FMC ? 

Tried the conf on the core switch  ( C6800 ) but the PO and physical links don't go up 

and could someone tell if the channel group on the switch should be ON or Active?

 

thanks,

1 Reply 1

Bogdan Nita
VIP Alumni
VIP Alumni

Here is a guide on configuring the port-channel:

https://www.cisco.com/c/en/us/td/docs/security/firepower/622/configuration/guide/fpmc-config-guide-v622/aggregate_interfaces_and_lacp.html#ID-2239-000001b5

 

Regarding the channel group mode, port-channel config on the switch should match the firepower LACP config. So if you activate LACP on the firepower you should have active on the switch, if you do not activate LACP you should have mode on. I would recommend having LACP.

 

HTH

Bogdan

Review Cisco Networking for a $25 gift card