FPR 2110 reimage tftp issue "download failure - timeout error (1)".

[free3lectron]

Hello Community members,

I have factory reset an FPR-2110 and trying to upload the latest OS 7.0.4-55. 

When I boot and get into rommon mode, I use the tftp command to download the new OS to boot. This takes me to the FXOS cli. When I try to upload the OS using scope firmware > download image tftp://<ip>/cisco-ftd-fp2k.7.0.4-55.spa, it gives me error while trying to download the file from tftp server.

under the "show download-task detail", following error is listed:  - "download failure - timeout error (1)".

At this point, I have tried changing the tftp server, software etc but the outcome is same mentioned above.

Has anyone seen this happening with the fresh upgrade or has there been any bug reported? 

Thanks

f3

[marce1000]

 - Check the tftp server's logs , if no activity is seen when this is tried, then there probably is a basic connectivity problem with the TFTP server.

 M.

[CiscoBrownBelt]

Had this issue too. DId not properly allow program on laptop and had syntex incorrect.