- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-22-2019 08:50 AM - edited 03-22-2019 08:51 AM
Hi,
Based in the following link: https://www.cisco.com/c/en/us/td/docs/security/firepower/fxos/fxos241/cli-guide/b_CLI_ConfigGuide_FXOS_241/interface_management.html#id_20107 in application management in FTD they have the following interface type:
- Data (Regular data, failover, link state)
- Data-sharing
- Mgmt
- Firepower-eventing
- Cluster
The link explained this hypothetical scenario:
Typical Multi-Instance Deployment
But, In a Multi-instance scenario and excluding the cases:
- physical Chassis Management Interface used by FXOS to connect to an FMC as example or CLI purpose.
- Data type Failover and link state restricted to the same parent interface and type.
Can I mix in a same parent interface Data, Data-sharing and Management type using sub-interfaces?
Thanks,
Regards,
Solved! Go to Solution.
- Labels:
-
Firewalls
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-23-2019 07:59 AM
The answer is no.
you need seperate physical interfaces for Data, management, and chassis management.
But the Data interface can be split into subinterfaces.
Please remember to select a correct answer and rate helpful posts
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-23-2019 07:59 AM
The answer is no.
you need seperate physical interfaces for Data, management, and chassis management.
But the Data interface can be split into subinterfaces.
Please remember to select a correct answer and rate helpful posts
