cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
541
Views
2
Helpful
3
Replies

FTD Route Based VPN question

benolyndav
Level 8
Level 8

Hi

I have a static Route Based VPN and am wondering if I create a loopback interface on the FTD is there a way to allow this IP over the VPN to test the VPN or generate some traffic from the FTD across the VPN ??

 

Thanks

1 Accepted Solution

Accepted Solutions

@benolyndav thats fine then. On the remote peer just create a static route pointing to your tunnel IP via the tunnel interface. You will need to permit the traffic in the firewall rules.

View solution in original post

3 Replies 3

@benolyndav as long as the peer has a route over the VPN to that loopback IP address and firewall rules that should work. I assume you aren't using the loopback as the tunnel source?

@Rob Ingram No not using Loopback as tunnel source 

 

Thanks

@benolyndav thats fine then. On the remote peer just create a static route pointing to your tunnel IP via the tunnel interface. You will need to permit the traffic in the firewall rules.

Review Cisco Networking for a $25 gift card