Hello, we have a new install of FTDv to try it out before buying an appliance, we tried deploying to Hyper-V and also to VMware. VMware install was completely dead with no communication to the outside world (I presume it wants 10gig interfaces we dont have atm). So we switched to hyper-v. Appliance installed, interfaces assigned, first boot done via CLI, IPs assigned, I can do:
ping 8.8.8.8
and it is successfull, but
ping system 8.8.8.8
is dead
The appliance has an ARP entry, but is not pingable on any interface. Interface outside has DHCP assigned address, that responds to ping, inside interface has 192.168.45.1 which even having statically set IP, does not respond to anything (not even HTTP/HTTPS). Management0/0 shows IP as unassigned
tried to manually configure the network (conf netw ipv4 manual ip_add mask gw) which shows success, but nothing happens.
This is 7.6.0 build. Can anyone tell me if this software is even working? Because right out of the box, not a great experience before handing out money to physical appliance.
Thank you
